how to remove the ashtray from a honda passport

You search Auto repair manual PDF about how to remove the ashtray from a honda passport, search results will appear below. If search results do not exist, please search by others keyword.

1999-2000 Honda Passport Stereo/Radio Installation Procedures


Filed Under (Honda) by admin on 12-07-2012

the stereo dock. Unplug the stereo wiring from the again of the factory radio. Disconnect the antenna cable from the back panel of the radio. 7. Take away the two screws on both sides of the bracket to free the factory radio. 8. Place the brand new stereo in the stereo mounting bracket. Screw in the two screws on both side of the bracket to secure the brand new stereo. 9. Join the stereo wiring to a wiring harness adapter. The stereo wiring is gr…

Honda V6 Engine Serpentine Belt Installation Instructions


Filed Under (Honda) by admin on 02-07-2012

…ne bay. Full this step from the engine bay and not from beneath the vehicle. 5. Place the brand new belt into the engine bay and route the belt around all the pulleys besides the tensioner pulley. Use your diagram as a guide. 6. Get under the Honda V6 again, push up on the ratchet driver handle and secure the belt over the tensioner pulley….

1996 Honda Accord Stereo/Radio Replacement


Filed Under (Honda) by admin on 11-04-2013

rd to entry the sprint panel screws near the gear selector lever. 6. Take away the two screws on the entrance aspect of the gear selector lever meeting with a Phillips-head screwdriver. 7. Pull the ashtray from the dashboard. 8. Take away the screw on the rear of the ashtray opening with a Phillips-head screwdriver. 9. Lift the dash panel that surrounds the stereo and the gear selector lever away from the dashboard. Grab the panel near the center…

2009 Honda Pilot Honda Music Link Installation – Page 1


Filed Under (Honda) by admin on 11-01-2014

connector). 5. Transfer the entrance passenger’s seat all the way rearward. 6. Remove the passenger’s console cowl (eight clips). 7. Take away the passenger’s side decrease panel (three clips and two pins). 8. Remove the glove field (two bolts). 9. Take away the pocket (two self-tapping screws, 4 clips and unplug the vehicle connectors). 10. Remove the audio (4 screws and unplug the car connectors). 11. Whereas pushing down on…

Honda Civic Coilover Springs Installation Procedures


Filed Under (Honda) by admin on 24-11-2012

…e elements, however some don’t. When disassembling the springs, a spring compressor needs to be used to safely hold the pressure of the springs. Assemble the brand new coilover springs using these elements if necessary. 5. Set up the new coilover springs in place of the outdated assembly. Reverse the steps and install all of the bolts that have been removed. The jack may be used under the management arm to boost the brand new coilovers into…

Honda Civic Thermostat Removal and Installation Procedures


Filed Under (Honda) by admin on 01-03-2012

the engine side. Use a Phillips screwdriver, rib joint pliers or ratchet and socket, depending on clamp type used on your explicit Honda Civic. 6. Unscrew the three thermostat housing mounting bolts with a ratchet and socket. 7. Take away the thermostat housing, thermostat unit and O-ring or rubber seal. Honda Civic Thermostat Installation Procedures 1. Set the brand new thermostat in place together with a brand new O-ring or rubber seal. 2. Set…

Honda Pilot FWD/4WD ReadyLift Suspension Installation Instructions


Filed Under (Honda) by admin on 18-03-2013

way loose. 7. Insert the knuckle into the lower strut mount. A C-Clamp may be needed to align the mounting holes. Insert the OEM hardware and tighten to 200 lb-ft. Tighten the three higher strut mounting nuts (14mm) 30 lb-ft. 8. Install the equipped sway bar end link. Tighten to eighty five lb- ft. Reinstall the brake line assist bracket and ABS line help bracket using the OEM hardware. 9. Remove the rear wheels. Unbolt the higher shock mounting…

1994-1998 Honda Accord Stereo/Radio Replacement


Filed Under (Honda) by admin on 28-01-2012

ift up the end of the panel closest to the gear shift. The highest of the panel above the radio snaps into the dash. Unsnap the top of the dash and set the sprint panel off to the aspect so you may achieve entry to the radio. 8. The radio is attached to the pocket beneath the radio as one unit or meeting and shall be eliminated as one unit. Once the middle dash console is pulled away from the radio, the radio/pocket meeting becomes visible. Below…

Honda Element Audio Amplifier Installation Instructions


Filed Under (Honda) by admin on 14-07-2012

…er wiring kit) to the wiring harness adapter and route the cables to the rear of the Honda. Guantee that the signal cable is routed on the alternative side of the Element as the facility supply to keep away from interference. 8. Connect the flip-on lead, the sign cable and the power provide to the amplifier. Connect speaker wire from the amplifier to the audio system you want amplified. Use the identical route established by the rear speakersR…

Honda Accord Aftermarket CD Player Installation Instructions


Filed Under (Honda) by admin on 02-07-2012

d the stereo with the screwdriver or eight-mm socket and nut driver. 7. Disconnect the 2 wiring connectors from the rear panel of the manufacturing unit stereo. Unplug the antenna cable from the back panel of the stock radio. 8. Place the installation kit faceplate adapter into the vacant stereo mounting dock. Pull the stereo wiring teams through to the entrance of the Accord’s dash. 9. Plug the plastic connectors at the end of the Honda…

You might also likeclose