fuel pump fuse location on 2002 ford f 150 truck

You search Auto repair manual PDF about fuel pump fuse location on 2002 ford f 150 truck, search results will appear below. If search results do not exist, please search by others keyword.

Ford Escape Fuel Pump Removal and Installation Instructions

37

Filed Under (Ford) by admin on 03-02-2012

…the half of-inch disconnect instrument quantity 310-D005 or equivalent. 8. Unplug the vapor gas line at the gas pump module by squeezing the side tabs at the finish of the fitting and pulling the line apart from the fitting. 9. Unscrew the fuel pump module from the gasoline tank using the fuel tank sender wrench quantity 310-069 or equivalent. 10. Remove the fuel pump module and O-ring seal from the fuel tank. Ford Escape Fuel Pump Installation…

Ford F-350 Fuel Pump Installation Instructions

32

Filed Under (Ford) by admin on 08-05-2013

…ecrease and remove the ground jack holding the tank in place. 7. Attach the wheel back on the truck using the inventory tire iron or one among your own, and lower the truck. Connect the cable to the negative battery terminal. 8. Fill the tank with not less than 5 gallons of fuel and pressurize the fuel system. With the Fuel Pump relay and fuse related and the gas cap on, turn the ignition on for 2 seconds. Switch it off and leave it off for 10 se…

1995 Buick Skylark Fuel Pump Installation Instructions

33

Filed Under (Buick) by admin on 21-02-2012

ys beneath it. 8. Use a hammer and small screwdriver to take away the lock ring, which holds the fuel pump in place. It is a metallic circle that has 3 or 4 tabs. Tap the ring in any direction to launch it from the fuel pump. 9. Take away the fuel pump completely. Make a psychological word of how the fuel pump comes out because that’s the same way it should go back in. Don’t spill fuel on the ground to keep away from a hearth hazard….

Ford 390 Fuel Pump Installation Instructions

33

Filed Under (Ford) by admin on 15-11-2012

ace on the engine. 7. Apply gasket sealant to the remaining side of the brand new gas pump gasket. 8. Press the replacement fuel pump against the gasket, then install the pump’s two retaining bolts with a socket wrench. 9. Tighten the in-line nut on the tip of the steel outlet line onto the bottom of the gas pump. 10. Press the tip of the rubber inlet line onto the metallic nipple on the underside of the fuel pump, then tighten the lineR…

Toyota Corolla Fuel Filter Installation Instructions

26

Filed Under (Toyota) by admin on 23-02-2012

ch. 7. Press the vent line on its fitting until the lock snaps in place; then set up the fuel line and safe it with the clip; plug the fuel pump vapor stress sensor electrical connector and the fuel pump electrical connector. 8. Join the black, adverse battery cable and set up the fuel tank filler cap. Start the engine and test for leaks; then flip off the engine and set the fuel pump assembly service cowl in place. Set up the mounting screws or…

Ford F-150 Water Pump Removal and Installation Instructions

22

Filed Under (Ford) by admin on 15-11-2012

nterclockwise with a socket, socket extension and socket-wrench whereas the fan-drive belt is still installed. 7. Take away the fan-drive belt. 8. Take away the fan meeting together with the fan pulley, fan spacer and shroud. 9. Take away the alternator bracket, alternator pivot bolt and energy steering pump bracket from the water pump by turning the bolts counterclockwise with a socket and socket-wrench. 10. Remove all 14 bolts that join the wat…

Ford 233 6-Cylinder Engine Fuel Pump Installation Instructions

30

Filed Under (Ford) by admin on 05-05-2012

ck and operates at three to four pounds per sq. inch, which is far lower than modern fuel-injected engines. You could want to install a new fuel pump if your 223 six is difficult to start or stumbles on acceleration. Ford 233 6-Cylinder Engine Fuel Pump Installation Instructions 1. Open the hood. Locate the fuel pump, mounted to the driving force’s facet of the engine block, roughly halfway between the entrance and rear of the motor. 2. Loo…

Ford F-Series Water Pump Installation Instructions

26

Filed Under (Ford) by admin on 04-08-2012

Use the jack to elevate the Ford F-Series truck once again. Take off the underbody splash shield and lower radiator hose still related to the water pump. Launch the jack. 6. Take off the bolts on the water pump, which include 9 bolts and stud bolts. Clean the floor of the mount. Install the Water Pump 1. Prepare the brand new gasket onto the water pump. Instead of sealant, Ford recommends lubricating your gasket with coolant. Maintain the gasket…

1998 Buick Regal GS Pontiac Grand Prix GTP Fuel Pump Resistor Replacement

25

Filed Under (Buick, Pontiac) by admin on 04-03-2013

(2-wire) connector from the sheet metallic subsequent to the battery and disconnect the connector. Pull the resistor wiring and connector down and out from below the vehicle. Discard the fuel pump resistor and mounting bolt. 9. Reinstall the windshield washer reservoir rear mounting bracket to the body and install the bolt. Tighten the bolt to 7 NJm (62 lb ft). Install the 2 bolts that attach the windshield washer reservoir to the rear mounting…

1997 Buick Regal GS Pontiac Grand Prix GTP Fuel Pump Resistor Replacement

27

Filed Under (Buick, Pontiac) by admin on 22-03-2013

nnector that was related to the resistor via the opening in the sheet steel and into the engine compartment. When correctly routed, the connector needs to be getting into the engine compartment simply rearward of the battery. 9. Verify that the black conduit on the wiring harness is defending the wiring from any sharp edges in the sheet metal opening. Reposition the conduit and harness if necessary. 10. Reposition and align the inner fender splas…

You might also likeclose