cleaner and paper towel. The area intended for antenna mounting should have 3 inches of metal on all sides surrounding the site–this will allow the strongest reception. Stick the magnetic antenna onto the cleaned area. 4. Run the antenna wire from the antenna’s mounted location into the truck. Use a putty knife or credit card to pry the molding around the rear windshield to allow space for the wire. Place the wire in the space provid…

ion. The docking cradle is designed to fasten onto the within of your windshield behind the rear view mirror; however, be at liberty to attach the docking cradle wherever inside the automotive that’s convenient for you. 4. Connect your Sirius Satellite Radio plug-and-play receiver to the docking cradle. Doing so gives the receiver power and a signal. 5. Tune your Honda Accord’s terrestrial radio to match the frequency your Sirius Sate…

of your Toyota Camry. Connect the power cable ring latch to the optimistic battery post. Connect extra power cable to this starter energy cable as needed. Disconnect the fuse from its holder earlier than connecting this wire. 4. Open the Camry’s nearest door and remove its trim panel. Run more power cable by way of the uncovered cavity and into your Camry, under the carpet, as needed. 5. Take away your stereo receiver from the dashboard. In…

to the back of the receiver and run alongside your sprint towards the passenger side. Tape the wire in place while rigorously preserving the wire tight — if the cord is too unfastened you will have to reattach it later. 4. Work your method to the back proper passenger window and punctiliously peel off the top of the rubber molding. Run the twine by the molding and up by the highest of the back proper passenger window. 5. Attach the connecto…

he four screws that secure the radio in the sprint, two on every side. Pull the stereo out of the dash and disconnect the wires behind the head unit. Search for an amplifier behind the stereo and take away the wires if found. 4. Connect the wiring harness adaptor to the original harness, use the wire from the amplifier if there’s one. Slide the brand new stereo into the Toyota radio adaptor and secure it per the producer’s instruction…

…holder containing the burnt-out tail light toward the back of the automobile (clockwise for the precise-hand side, and counterclockwise for the left-hand facet) and pull outward. It should come free of the encompassing frame. 4. Press down on the holder’s lock release to detach the old bulb. Then match the brand new bulb in its place. Ensure the lock has snapped shut and the new bulb is safe in its housing before continuing. 5. Slide the ho…