ant on the brand new water pump and place the new gasket over this. Hold the gasket in place on the pump as you mount it on the engine, where you removed the old pump. 2. Maintain the water pump in place as you secure it with 4 new bolts. Tighten every in any order with 13 foot pounds torque. Reassemble the rest of the components within the order you took them off the Ford Focus. Exchange any parts that appear worn or broken as you go. 3. Replace…

…e Ford DIN removing keys into the holes at either end of the manufacturing facility stereo deck. Push the keys into the stereo till they lock into place. Pull outward on the keys whereas sliding the stereo from the dashboard. 5. Disconnect the two white, plastic stereo wiring connectors from the retailers on the back of the stereo. Plug the connectors into the wiring harness adapter leads. Connect the wiring harness adapter lead connectors to the…

f the front axles and set them out of the way. 4. Put the catch pan beneath the brake assembly on the left entrance and spray the brakes down thoroughly with brake cleaner. Remove as much brake mud as possible with the spray. 5. Unbolt the brake caliper with the socket set and pull the caliper off the brake rotor by hand. 6. Pull the retaining clip off the again of the brake caliper and take the previous Brake Pads out of the caliper by hand. Spr…

e pipe clips securing the pipe to the underbody. Remove the clips from the underbody and discard.Disconnect the vent valve pipe at the EVAP canister. 4. Take away and retain the EVAP canister vent valve bracket mounting bolt. 5. Remove the entire EVAP canister vent valve meeting with bracket attached and discard. 6. Important: The new canister vent valve shall be put in in a new location, outdoors of the frame. Position and secure the new valve a…

…formed you was bad. The sensor screws into portholes in the exhaust pipes forward of the catalytic converter. There may be one close to the manifold within the front pipe area and another one close to the catalytic converter. 5. Comply with the wire of the O2 Sensor to the plug and unplug it. Use the flathead screwdriver to press in the clip lock and separate the plug. 6. Place the oxygen sensor socket onto the ratchet and remove the O2 sensor fr…

will not have openings for the DIN removal tools or the Ford factory mounting brackets, you will have to install it using a faceplate kit. The faceplate kit slides into the opening and is seated when it clicks on both sides. 5. Connect the wiring harnesses for the four wire groups into the CD player. (In any order). 6. Slide the CD Player into the faceplate installation kit opening until flush with the face of the kit. 7. Reconnect the grounding…