Search Result for " 2004 gmc envoy block heater cord" :

2003 Honda Element Engine Block Heater Installation Procedures

34

Filed Under (Honda) by admin on 11-04-2013

2003 Honda Element Engine Block Heater Installation 1. Permit the engine and all cooling system elements to cool down. 2. Place a clean drain pan beneath the radiator drain plug, then take away the drain plug from the bottom of the radiator to drain the coolant. Remove the radiator cap to increase the flow. 3. Open the hood and remove the radiator cover (5 clips). 4. Remove the radiator mount bracket (two bolts). 5. Remove the drain plug f…

Loss of Communication with Brake Module (Reground EBCM Ground)

27

Filed Under (Cadillac, Chevrolet, GMC, Oldsmobile) by admin on 09-04-2013

hers and nuts specified in this bulletin. These parts have been identified because of their conductive finish. 4. Install a washer and nut to the back facet of the frame. Tighten Tighten the nut to 9 N·m (seventy nine lb in). 5. Cover the front and back aspect of the restore area using Rubberized Undercoating. An additional test may be made to ensure an excellent connection for the Battery Cable to Body ground. It’s potential for this groun…

Ford Taurus Heater Bypass Installation Instructions

31

Filed Under (Ford) by admin on 05-01-2012

…er, which is just a short pipe that may be bought at any auto parts store and is inexpensive. The heater hoses shouldn’t be cut as a result of they are expensive and can be wanted again when the heater core is replaced. 3. Fill the radiator to the correct degree with antifreeze and leave the radiator cap off for the moment. Start the engine and permit it to heat up. Once the engine warms sufficient to open the thermostat, the fluid level wi…

2007 Honda Pilot LX Roof Rack Installation Instructions

27

Filed Under (Honda) by admin on 27-05-2014

secure it with two Torx bolts. Install the No. 2 adapter block behind the No. 1 block and the No. 3 adapter block behind the No. 2 block utilizing the stud bolts. Repeat this step on the left facet with adapter blocks Nos. 4, 5 and 6. 3. Measure the passenger-aspect roof molding 674 mm from the entrance end. Minimize it with a hack saw. Install the shorter piece in front of adapter block 1. Measure a hundred and fifty five mm from the front of th…

2004 Ford Mustang GT Headlights and Fog Lights Installation Instructions

36

Filed Under (Ford) by admin on 27-04-2013

the again of the headlight bulb. 4. Twist the plastic headlight bulb retaining ring to the left, pull it off of the headlight meeting and then pull the headlight bulb out of the assembly. Discard the previous headlight bulb. 5. Insert the replacement headlight bulb into the headlight meeting, slide the headlight bulb retaining ring onto the assembly and twist it to the correct to lock it in place. 6. Plug the electrical connector onto the headli…

Ford F-150 Water Pump Removal and Installation Instructions

22

Filed Under (Ford) by admin on 15-11-2012

hose from the Water Pump assembly using a flat-head screwdriver and turning the hose-clamp screw counterclockwise until the clamp is loose. The water pump is situated on the entrance of the engine block dealing with the fan. 5. Pull each hose away from the water pump meeting by hand till the hoses are disconnected from the water pump. 6. Take away the four bolts connecting the water pump pulley to the water pump by turning them counterclockwise…

Replace Evaporative Emission Vent Valve Solenoid – Page 2

29

Filed Under (Chevrolet, GMC) by admin on 16-04-2013

r vent valve electrical connector. 3. Disconnect the canister pipe from the vent valve. 4. Push in the retainer and take away the present canister vent valve from the fuel tank clip or mounting bracket. Discard the old valve. 5. Reduce the present canister pipe approximately fifty one mm (2 in) to take away the short join end. Crew Cab Brief Field Shown Under, Different Configurations Comparable Prolonged Cab Quick Field Shown Below, Other Config…

2004-2005 Pontiac Grand Prix Plenum Water Deflector

32

Filed Under (Buick, Pontiac) by admin on 14-01-2012

Subject    : Water Leak On Front Passenger Floor (Install Plenum Water Deflector) Models     : 2005 Buick LaCrosse, Allure (Canada Only) 2004-2005 Pontiac Grand Prix Set up the new plenum water deflector. Follow the process under: 1. Place the windshield wipers in the up position. 2. Open the hood. 3. Take away the hood seal. 4. Take away the washer hose from the precise air inlet grille panel. 5. Remove the push pin that retains the air inle…

Honda Civic Turbo Systems Installation Procedures

25

Filed Under (Honda) by admin on 19-05-2013

…ect the turbocharger to the exhaust manifold with an exhaust gasket in between. Safe the turbocharger with the bolts provided and tighten with a ratchet. 4. Install the new turbo manifold onto the engine block with a ratchet. 5. Connect the oil feed line from the engine block to the turbocharger. You possibly can faucet into the engine block on the oil pressure sensor. 6. Remove the oil pan and send it to a welder to have an oil return bung welde…

Ford 233 6-Cylinder Engine Fuel Pump Installation Instructions

30

Filed Under (Ford) by admin on 05-05-2012

rt for installation of the substitute fuel pump. 4. Pull the pump straight out of the engine block and remove it from the engine bay. Scrape any gasket reside from the mounting floor of the engine block with a gasket scraper. 5. Place a new gasket over the mounting floor of the substitute gas pump and maintain it to the mounting surface on the engine block, lining up the mounting holes. Thread the original retaining bolts through the pump and int…

You might also likeclose