ar assembly. Take away the power steering stress hose meeting from the vehicle. 6. Set up the ability steering pressure hose assembly to the vehicle. Join the power steering strain hose to the facility steering pump assembly. 7. Connect the facility steering stress hose to the power steering gear assembly.Tighten the ability steering pressure hose to the steering gear to 27 N·m (20 lb ft). 8. Install the bolt/screws to the retaining clips (three)…

…f the pump, and drain the pump into the cup. 3. Take away the nuts which can be holding the pump onto the firewall, utilizing the wrench. Remove the belt on the pump from the pulley. Pull the old pump from the engine housing. 4. Secure the new pump onto the firewall with the securing nut. Exchange the belt to the pulley on the pump. Exchange the strains to the right holes on the pump. Tighten the nuts on the firewall and pump lines. Fill the pump…

the water pump. 6. Take away the four bolts connecting the water pump pulley to the water pump by turning them counterclockwise with a socket, socket extension and socket-wrench whereas the fan-drive belt is still installed. 7. Take away the fan-drive belt. 8. Take away the fan meeting together with the fan pulley, fan spacer and shroud. 9. Take away the alternator bracket, alternator pivot bolt and energy steering pump bracket from the water pu…

…eering column. Remove the steering wheel bolt and nut with a socket wrench and pull the old steering wheel off the steering column. 6. Place the new steering wheel onto the steering column and secure it with the nut and bolt. 7. Reattach the horn cap and its electrical connector as well as the steering wheel cover and its electrical connector. Secure the steering wheel cover by reinstalling the two Torx screws behind the steering wheel. Reconnect…

pump meeting and the tank. Mark the lines with masking tape and a permanent marker (A, B and C from left to proper), so you’ll be able to change them on the new fuel pump exactly the way in which they have been removed. 7. Set the fuel tank down onto the rubber mat to ensure that you do not create any sparks or static electricity when shifting the tank from underneath the car. Pull the tank out from beneath the car, making sure that the rub…

e car on a hoist. At the right front wheel opening, remove the three screws that connect the inside fender splash shield to the entrance fascia at the wheel opening and the 2 screws that attach it to the bottom of the fascia. 7. Reposition the internal fender splash shield to entry the fuel pump resistor. Unclip the fuel pump resistor electrical connector from the body and disconnect the connector. 8. Remove the 10mm hex head bolt attaching the f…