Filed Under (Ford) by admin on 05-03-2013
…troublesome and will require wire cutters to convert wiring harnesses and a screwdriver to take away the radio mount. Replacing a Ford Radio is similar in every vehicle except for the F250 and autos geared up with the Shaker 500 stereo. Removing the Stock Ford Radio Disconnect the detrimental battery cable in your Ford vehicle before attempting to work on the radio. Wiring components may cause electrical shock; disconnecting the destructive batt…
Filed Under (Ford) by admin on 30-10-2012
…of the faceplate adapter. 4. Connect the leads of the wiring harness adapter to the retailers on the again of the aftermarket stereo/radio. Slide the aftermarket stereo into the opening offered by the Ford faceplate adapter. 5. Place the negative battery cable clamp across the detrimental lead put up of the Ford battery. Tighten the bolt on the clamp with the ten mm wrench so that the clamp can not move freely in regards to the lead post….
Filed Under (Ford) by admin on 09-04-2013
ess adapter. Connect the opposite finish of the adapter to the wire harness of the new radio. Push the connections collectively and click them into place. Attach the radio antenna to the offered port on the rear of the radio. 5. Slide the related radio into the radio installation sleeve. Push it in until it clicks into place. Reconnect the car battery. Turn on the radio to check the installation….
Filed Under (Ford) by admin on 11-11-2012
…the Escape. 4. Remove the trim panels at the bottom of the door openings with a trim panel elimination tool. Lift the carpeting and route the ability cable to the rear cargo space of the Ford. Change the trim panels by hand. 5. Remove the Ford stereo. Place the DIN elimination tools into the stereo removal holes located on both side of the stereo’s face. Pull the tools outward whereas pulling the stereo from the dash. Pull the stereo far e…
Filed Under (Ford) by admin on 11-03-2013
…e adapter from the Ford installation equipment into the stereo mounting dock. Push the faceplate adapter into the opening till it snaps into place. Attain into the adapter to tug forth the leads of the wiring harness adapter. 5. Plug the wiring harness adapter leads into the corresponding outlets on the back of the brand new stereo/radio. Plug the antenna cable into the outlet on the rear panel of the stereo labeled “FM antenna.” 6. S…
Filed Under (Ford) by admin on 17-04-2013
…to the dash. Run the wiring through to the front of the opening and connect it to a wiring harness adapter. Attach the wiring harness adapter results in the brand new stereo. Plug the antenna wire into the aftermarket stereo. 5. Put the brand new stereo into the faceplate adapter package till it snaps into place. 6. Replace the battery cable clamp onto the destructive lead publish and tighten it with the screwdriver….